Request A Quote
9 Metre PCC Pole Manufacturer

PSC poles shall comply with the recommendation of REC as per the specification 15/1979 (with latest amendment) excepts where the conflicts specific requirement, with the above REC specification, the pole shall comply with the relevant provisions made in the following ISS specification.

  • Poles shall have the factor of safety 1.0 against first crack load and not less than 2.0 against failure for loads applied at .06 meter from top with 1.6 meter of pole inside the ground. The guaranteed minimum ultimate transverse load shall not be less the 800 kgs.
  • The concretes mixture shall designed to the requirement laid down to controlled concrete in ISS: 1343/1980 and ISS: 456/1973. Cubes strengths at 20 days shall not be less than 420 kg/mm2. The maximum compressive stress in concrete at the time of transfer of pre stressed shall not exceed 0.8 times.
  • The ultimate moment capacity in the longitudinal direction should be at least one fourth of that in the transverse direction.The cube strength and concrete strength at transfer shall not be less than half the 28 days strength i.e. 420 X 0.5 = 210 kgs/mm2. The concrete shall be mechanically compacted by shuttering vibrators.
  • 9 Metre PCC Pole Supplier

    Physical specification

    Pole shall be rectangular in cross section. The top section shall be 225 MM X 100 MM and bottom section 395 MM X 100MM total length of 9 meters, over all weight of 700 kgs. Each pole shall be provided with 18 MM dia through holes suitable for 16 mm disc bolt at the following distance from the top along the minor axis.Each pole shall be provided with pre stressing steel wire of 4MM diameter with guaranteed ultimate’s strength of 175 kgs/mm2, 20 nos. as tensioned wire.
    Along the minor axis 2 holes.

    • 1st hole at 100 MM from top
    • 2 hole at 200MM from top.

    9 Metre PSCC Pole Manufacturer

    Technical specification

    PSC poles shall comply with the recommendation of REC as per the specification 15/1979 (with latest amendment) excepts where the conflicts specific requirement, with the above REC specification, the pole shall comply with the relevant provisions made in the following ISS specification.

    • ISS:1678/1978
    • ISS:2985/1966
    • ISS:7321/1974

    Each Pole Shall Be Embossed Or Engraved With

    Each pole should be provided for earthing 8 SWG wire embedded in concrete during manufacturing in such a way that the end of the wire are left projecting from the pole to a length of 50 mm at 250 mm from top and 150 mm below ground level. i.e. 1350 mm from bottom end. The earthing wire so provided shall not be allowed to come in contact with pre stressing wires. The above provision shall be made as per the drawing. Further each pole shall be provided with M.S stirrups as per ISS 432/1966 with anneals wire of ultimate strength of 32 kg/mm square and 4 mm M.S wire ten in numbers spread throughout the length at suitable spacing. Permissible tolerance in plighting shall fully confirm to relevant provision of ISS: 1342/1980 and ISS: 1678/1978 and the latest publications.

    • Month and year of manufacture.
    • Makers name, serial number and making symbol
    • Transverse strength of pole in kg
    9 Metre PSCC Pole Manufacturer